INSTALLATION

(1) Place Special Seal Pilot Tool C-4681 on crankshaft (Fig. 9).

(2) Lightly coat seal O.D. with Loctite Stud N' Bearing Mount or equivalent.

(3) Place seal over Special Seal Pilot Tool C-4681 and tap in place with a plastic hammer.

REAR CRANKSHAFT SEAL RETAINER

When retainer removal is required, remove retainer clean engine block and retainer of old gasket. Make sure surfaces are clean and free of oil. Install new gasket and tighten screws to 12 Nzm (105 in. lbs.).

Fig. 7 Measuring Bearing Clearance with Plastigage

CAUTION: Do not rotate crankshaft or the Plastigage may be smeared.

CRANKSHAFT OIL SEALS SERVICE

REMOVAL

Pry out rear seal with screwdriver. Be careful not to nick or damage crankshaft flange seal surface or retainer bore (Fig. 8).

Fig. 9 Installing Rear Crankshaft Oil Seal

Fig. 8 Removing Rear Crankshaft Oil Seal