Ä

Fig. 1 Removing Brake Shoe Hold-Down Clip

(7)Turn parking brake, brake shoe adjuster wheel until adjuster is at shortest length.

(8)Remove the parking brake, shoe adjuster assembly (Fig. 2).

Fig. 2 Removing Adjuster Assembly

(9)Remove upper parking brake, shoe to shoe spring (Fig. 3).

(10)Pull front parking brake shoe, away from anchor. Then remove front parking brake shoe and lower spring (Fig. 4).

BRAKES 5 - 63

Fig. 3 Removing Upper Spring

Fig. 4 Removing Shoe and Lower Spring

(11) Remove rear parking brake shoe hold-down clip. Then remove rear parking brake shoe assembly (Fig. 5).

INSTALLING PARKING BRAKE SHOES

(1)Install rear parking brake shoe and holddown clip (Fig. 6).

(2)Install lower parking brake, shoe to shoe return spring (Fig. 7).

(3)Pull forward parking brake shoe over anchor block until properly located on adapter.

Fig. 5 Removing Rear Holddown Clip and Shoe

Fig. 6 Installing Rear Shoe and Hold-Down Clip

(4)Install upper parking brake, shoe to shoe return spring (Fig. 8).

(5)Install parking brake shoe adjuster assembly with star wheel forward (Fig. 9).

(6)Install front, parking brake shoe holddown clip (Fig. 10).

(7)Adjust parking brake shoes to a diameter to 171 mm (6.75 inch).

(8)Install hub assembly on spindle.

(9)Install outer bearing, thrust washer and nut.

(10)Tighten wheel bearing adjusting nut to 27 to 34 NIm (240 to 300 in. lbs.) torque while rotating hub. This seats the bearings.

Fig. 7 Installing Lower Spring

Fig. 8 Installing Upper Spring

(11)Back off adjusting nut 1/4 turn (90°) then tighten adjusting nut finger tight.

(12)Position lock on nut with one pair of slots in line with cotter pin hole. Install cotter pin.

(13)Install grease cap.

(14)Install rear braking disc.

Fig. 9 Installing Adjuster Assembly

(15)Install rear, disc brake caliper on the adapter (See Brake Shoe Removal).

(16)Install wheel and tire assemblies.

Fig. 10 Installing Front Parking Brake Shoe Hold-

Down Clip

(17) Tighten wheel stud nuts to 129 NIm (95 ft. lbs.).