5-36 ENGINE TOP END

Throttle Body Assy Holder

Throttle Body Assy Holder Removal

•Remove:

Throttle Body Assy (see Throttle Body Assy Removal in the Fuel System (DFI) chapter)

Clamps [A]

Throttle Body Assy Holder Bolts [B] Throttle Body Assy Holders [C]

Throttle Body Assy Holder Installation

•Be sure to install the new O-rings [A].

•Apply grease to the new O-rings.

•Install the holders [B] as shown in the figure. Recession [C]

•Apply a non-permanent locking agent to the threads of the throttle body assy holder bolts [D], and tighten them.

Torque - Throttle Body Assy Holder Bolts: 12 N·m (1.2 kgf·m, 106 in·lb)

•Fix the hole of the clamp [A] to the projection [B] of the holder [C].

25° [D] 10° [E]

•Tighten:

Torque - Throttle Body Assy Holder Clamp Bolts: 2.9 N·m (0.30 kgf·m, 26 in·lb)