Fig. 26 Intermittent Wipe Module

Fig. 27 Glove Box Lamp and Switch

(4)Remove four caps which cover attaching screws.

(5)Remove four attaching screws.

(6)Lift consolette up and over shift mechanism to remove.

(7)For installation reverse above procedures.

CENTER CONSOLE ASSEMBLY

REPLACEMENT

(1)Place transmission in neutral and remove shifter handle.

(2)Unsnap PRNDL bezel or shift boot bezel from console, disconnect wiring and remove bezel assembly (Fig. 28).

(3)Unsnap power window/mirror switch bezel, when so equipped and disconnect switch wiring.

(4)Remove two screws from side of armrest.

(5)Remove arm rest and center console section as a unit by lifting from the front and unsnapping from front console section.

(6)For installation reverse above procedures.

CONSOLE GEAR SELECTOR INDICATOR LAMP REPLACEMENT

(1)Place shifter handle in Neutral position.

(2)Remove handle from shifter.

(3)Unsnap gear selector bezel and pull upward (Fig. 28).

(4)Remove indicator lamp socket from bezel to replace lamp.

(5)For installation reverse above procedures.

FRONT CONSOLE ASSEMBLY REPLACEMENT

(1)Remove shifter handle.

(2)Unsnap PRNDL bezel or shift boot bezel from console assembly, disconnect wiring and remove bezel assembly (Fig. 28).

(3)Unsnap power mirror/window switch bezel, when so equipped and disconnect switch wiring.

(4)Open arm rest and remove three screws holding arm rest to center console retractor bracket.

(5)Remove armrest and center console section as a unit by lifting and unsnapping from forward console section.

(6)Remove center module bezel.

(7)Remove forward console and side walls as complete unit by removing six sidewall attaching screws to instrument panel and console bracket. Slide unit rearward and lift to remove.

(8)For installation reverse above procedures.

(a)For adjustment move gearshift lever with force into park position.

(b)Check gear selector indicator for proper align-

ment.

INSTRUMENT PANEL TOP COVER

REPLACEMENT

(1)Place trim-stick tool in groove between the panel top cover and pad surface (FIG. 29).

(2)Pry cover up and forward until released from instrument panel pad.

(3)Lift top cover upward and rearward to remove from vehicle.

(4)For installation place top cover on panel opening. Be certain that blades of top cover are located in the retaining spring clips.

(5)Push forward and down to engage in pad.

INSTRUMENT PANEL REPLACEMENT

CAUTION: Disconnect negative battery cable, in engine compartment, before servicing instrument panel.

(1) Remove windshield wiper arms.