panel down, attach a hook to hold in position.

(27)Open hood and remove plenum grill.

(28)Disconnect washer bottle, resistor block and under hood lamp wiring. Washer bottle must be removed to gain access.

(29)Remove grommet and pull plenum wiring into vehicle through plenum panel.

(30)Disconnect right demister hose from instrument panel.

(31)Disconnect antenna cable.

(32)Disconnect right and left 25 way body wiring connectors.

(33)Disconnect A/C heater control cables, wiring connectors and vacuum harness.

(34)Remove right side panel ground wire.

(35)Disconnect body controller wiring.

(36)Remove instrument panel assembly from ve-

hicle.

(37)For installation reverse above procedures.

INTERIOR LAMP REPLACEMENT

The reading, overhead console and door lamps operate when the doors are open or headlamp switch is placed in courtesy position. Front overhead lamps refer to Group 8C, Overhead Console.

TRUNK LAMP

The lamp has easily accessible without removing components.

DOOR LAMP

Pry along the forward edge of the lens and pivot lens out of the door trim panel. Remove lamp. To remove lamp housing, remove door trim panel. Refer to Group 23, Body. Disconnect all wiring. Remove screws, if so equipped securing lamp housing to trim panel, and replace housing.

CÐPILLAR READING/COURTESY LAMP

Pry along the rearward edge of the lamp and pivot lamp out from quarter trim panel. Disconnect wiring and remove lamp cover. Replace lamp.

The lamp operates when the doors are open or the headlamp switch is turned to the courtesy mode. The lamp will function as a reading lamp when the doors are closed and the button switch on the lamp is depressed.

ROOF RAIL READING

Pry along the bottom edge of the lens and pivot lens out. Replace lamp. To remove the lamp, remove the screw which retains the coat hook. Remove the garnish molding. Disconnect the wiring harness. Remove the two clips which retain the lamp to the molding. Replace lamp. The lamp operates like the C-pillar reading/courtesy lamp.