- •1 Debug system overview
- •Figure 1. Debug system block diagram
- •2 Communication layer
- •Figure 2. SWIM pin external connections
- •3 Single wire interface module (SWIM)
- •3.1 Operating modes
- •Figure 3. SWIM activation sequence
- •3.2 SWIM entry sequence
- •Figure 4. SWIM activation timing diagram
- •Figure 5. SWIM entry sequence
- •3.3 Bit format
- •3.3.1 High speed bit format
- •Figure 6. High speed bit format
- •3.3.2 Low speed bit format
- •Figure 7. Low speed bit format
- •3.4 SWIM communication protocol
- •Figure 8. Command format (Host -> Target)
- •Figure 9. Data format (Target -> Host)
- •3.5 SWIM commands
- •3.5.1 SRST: system reset
- •3.5.2 ROTF: read on the fly
- •3.5.3 WOTF: write on the fly
- •3.6 SWIM communication reset
- •3.7 CPU register access
- •3.8 SWIM communication in Halt mode
- •3.9 Physical layer
- •Figure 10. Timings on SWIM pin
- •3.10 STM8 SWIM registers
- •3.10.1 SWIM control status register (SWIM_CSR)
- •3.10.2 SWIM clock control register (CLK_SWIMCCR)
- •4 Debug module (DM)
- •4.1 Introduction
- •4.2 Main features
- •Figure 11. Debug module block diagram
- •4.3 Debug
- •4.3.1 Reset
- •4.3.2 Breakpoints
- •4.3.3 Abort
- •4.3.4 Watchdog control
- •4.3.5 Interaction with SWIM
- •4.4 Breakpoint decoding table
- •4.5 Software breakpoint mode
- •4.6 Timing description
- •Figure 12. STM8 Instruction Model
- •4.7 Abort
- •Figure 13. STM8 Debug Module Stall Timing
- •4.8 Data breakpoint
- •Figure 14. STM8 DM Data Break Timing
- •4.9 Instruction breakpoint
- •Figure 15. STM8 DM instruction break timing
- •4.10 Step mode
- •Figure 16. STM8 DM step timing
- •4.11 Application notes
- •4.11.1 Illegal Memory access
- •4.11.2 Forbidden stack access
- •4.11.3 DM break
- •4.12 DM registers
- •4.12.1 DM breakpoint register 1 extended byte (DM_BKR1E)
- •4.12.2 DM breakpoint register 1 high byte (DM_BKR1H)
- •4.12.3 DM breakpoint register 1 low byte (DM_BKR1L)
- •4.12.4 DM breakpoint register 2 extended byte (DM_BKR2E)
- •4.12.5 DM breakpoint register 2 high byte (DM_BKR2H)
- •4.12.6 DM breakpoint register 2 low byte (DM_BKR2L)
- •4.12.7 DM control register 1 (DM_CR1)
- •4.12.8 DM control register 2 (DM_CR2)
- •4.12.9 DM control/status register 1 (DM_CSR1)
- •4.12.10 DM control/status register 2 (DM_CSR2)
- •4.12.11 DM enable function register (DM_ENFCTR)
- •4.12.12 Summary of SWIM, DM and core register maps
- •Appendix A Description of the DM_ENFCTR register for each STM8 product
- •Table 6. Peripherals which are frozen by the bits of the DM_ENFCTR register for each STM8 product
- •Revision history
Revision history |
UM0470 |
|
|
Revision history
Table 7. |
Document revision history |
|||
Date |
|
Revision |
Changes |
|
|
|
|
||
15-Jan-2008 |
1 |
Initial release. |
||
|
|
|
|
|
|
|
|
Updated documentation references in Introduction. |
|
|
|
|
Section 3.2: SWIM entry sequence: updated Figure 4 and |
|
10-Dec-2009 |
2 |
explanation. |
||
|
|
|
Section 3.3: Bit format: replaced OBL bit with HSIT bit. |
|
|
|
|
Added Appendix A. |
|
|
|
|
|
|
|
|
|
Introduction: updated titles of reference documents. |
|
|
|
|
Updated name of ‘IOM’ bit to SWIM disable bit (SWD) in Section 3.1: |
|
06-Jun-2011 |
3 |
Operating modes, Figure 3, and SWIM control status register |
||
(SWIM_CSR). |
||||
|
|
|
||
|
|
|
Updated name of ‘MCR’ register to ‘CFG_GCR’ register in |
|
|
|
|
Section 3.1: Operating modes. |
|
|
|
|
|
|
36/37 |
Doc ID 14024 Rev 3 |
UM0470
Please Read Carefully:
Information in this document is provided solely in connection with ST products. STMicroelectronics NV and its subsidiaries (“ST”) reserve the right to make changes, corrections, modifications or improvements, to this document, and the products and services described herein at any time, without notice.
All ST products are sold pursuant to ST’s terms and conditions of sale.
Purchasers are solely responsible for the choice, selection and use of the ST products and services described herein, and ST assumes no liability whatsoever relating to the choice, selection or use of the ST products and services described herein.
No license, express or implied, by estoppel or otherwise, to any intellectual property rights is granted under this document. If any part of this document refers to any third party products or services it shall not be deemed a license grant by ST for the use of such third party products or services, or any intellectual property contained therein or considered as a warranty covering the use in any manner whatsoever of such third party products or services or any intellectual property contained therein.
UNLESS OTHERWISE SET FORTH IN ST’S TERMS AND CONDITIONS OF SALE ST DISCLAIMS ANY EXPRESS OR IMPLIED WARRANTY WITH RESPECT TO THE USE AND/OR SALE OF ST PRODUCTS INCLUDING WITHOUT LIMITATION IMPLIED WARRANTIES OF MERCHANTABILITY, FITNESS FOR A PARTICULAR PURPOSE (AND THEIR EQUIVALENTS UNDER THE LAWS OF ANY JURISDICTION), OR INFRINGEMENT OF ANY PATENT, COPYRIGHT OR OTHER INTELLECTUAL PROPERTY RIGHT.
UNLESS EXPRESSLY APPROVED IN WRITING BY AN AUTHORIZED ST REPRESENTATIVE, ST PRODUCTS ARE NOT RECOMMENDED, AUTHORIZED OR WARRANTED FOR USE IN MILITARY, AIR CRAFT, SPACE, LIFE SAVING, OR LIFE SUSTAINING APPLICATIONS, NOR IN PRODUCTS OR SYSTEMS WHERE FAILURE OR MALFUNCTION MAY RESULT IN PERSONAL INJURY, DEATH, OR SEVERE PROPERTY OR ENVIRONMENTAL DAMAGE. ST PRODUCTS WHICH ARE NOT SPECIFIED AS "AUTOMOTIVE GRADE" MAY ONLY BE USED IN AUTOMOTIVE APPLICATIONS AT USER’S OWN RISK.
Resale of ST products with provisions different from the statements and/or technical features set forth in this document shall immediately void any warranty granted by ST for the ST product or service described herein and shall not create or extend in any manner whatsoever, any liability of ST.
ST and the ST logo are trademarks or registered trademarks of ST in various countries.
Information in this document supersedes and replaces all information previously supplied.
The ST logo is a registered trademark of STMicroelectronics. All other names are the property of their respective owners.
© 2011 STMicroelectronics - All rights reserved
STMicroelectronics group of companies
Australia - Belgium - Brazil - Canada - China - Czech Republic - Finland - France - Germany - Hong Kong - India - Israel - Italy - Japan -
Malaysia - Malta - Morocco - Philippines - Singapore - Spain - Sweden - Switzerland - United Kingdom - United States of America
www.st.com
Doc ID 14024 Rev 3 |
37/37 |
