Chapter 5 - MPLAB |
|
|
|
Previous page |
Table of contents |
Chapter overview |
Next page |
5.2 MPLAB
Following the installment procedure, you will get a screen of the program itself. As you can see, MPLAB looks like most of the Windows programs. Near working area there is a "menu" (upper blue colored area with options File, Edit..etc.), "toolbar" (an area with illustrations the size of small squares), and status line on the bottom of the window. There is a rule in Windows of taking some of the most frequently used program options and placing them below the menu, too. Thus we can access them easier and speed up the work. In other words, what you have in the toolbar you also have in the menu.
The screen after starting the MPLAB
Chapter 5 - MPLAB
The purpose of this chapter is for you to become familiar with MPLAB developing environment and with basic elements of MPLAB such as:
Choosing a developing mode Designing a project
Designing a file for the original program
Writing an elementary program in assembler program language Translating a program into executive code
Starting the program
Opening a new window for a simulator
Opening a new window for variables whose values we watch (Watch Window) Saving a window with variables whose values we are watching
Setting the break points in a simulator (Break point)
Preparing a program to be read in a microcontroller can boil down to several basic steps:
Previous page |
Table of contents |
Chapter overview |
webmaster.
Chapter 5 - MPLAB |
|
|
|
Previous page |
Table of contents |
Chapter overview |
Next page |
5.3 Choosing the development mode
Setting a developing mode is necessary so that MPLAB can know what tools will be used to execute the written program. In our case, we need to set up the simulator as a tool that's being used. By clicking on OPTIONS---> DEVELOPMENT MODE, a new window will appear as in the picture below:
Setting a developing mode
We should select the 'MPLAB-SIM Simulator' option because that is where the program will be tried out. Beside this option, the 'Editor Only' option is also available. This option is used only if we want to write a program and by programmer write' hex file' in a microcontroller. Selection of the microcontroller model is done on the right hand side. Since this book is based on the PIC16F84, this model should be selected.
Usually when we start working with microcontrollers, we use a simulator. As the level of knowledge will have increased, program will be written in a microcontroller right after translation. Our advice is that you always use the simulator. Though program will seem to develop slower, it will pay off in the end.
Chapter 5 - MPLAB |
|
|
Previous page |
Table of contents |
Chapter overview |
webmaster.