Schematic

•Loading certain Tango Series Two Schematic files would cause a UC@SchEcMgr.cpp(2997). This has been corrected.

•Schematic has returned to its earlier speed. There is no longer a delay while trying to perform typical edits, such as moving components.

•Schematic's Copy Matrix once again honors the Net Increment value in the Options Configure dialog when copying a wire.

•DBX application performance has now been restored to its previous state when communicating with Schematic.

Library Management

•When translating a binary library to ASCII if there are any zero-radius arcs in the library they will be changed to a 0.001mil radius. This is to prevent problems occurring when translating the ASCII library to binary or importing into Altium Designer.

•Purging pad styles from the Options Pad Styles dialog while in the Pattern Editor will no longer purge styles that are being used by the alternate pattern graphics.

•Library Merge Patterns had a problem in that it would skip patterns with names of only a single character. This has been corrected.

System-level

•In the Pattern Editor if selecting using extended selection and then Copy and Paste would cause a UC@Line.cpp(3330). This has been corrected.

•NetSync no longer throws away the % sign in an attribute value when outputting an ECO.

•ASCII file read in Schematic and PCB would fail when trying to open the error log file if the folder was read-only, this no longer happens. In the case where the log file cannot be written to the ASCII file's folder, it will be opened and written to the executable folder.

•DBX will now run as quickly with the Options»Configure»AutoSave enabled as it does with AutoSave disabled. NOTE: AutoSave will be disabled while DBX is running.