Fig. 11 Seat Adjuster±AG Body

(1)Remove seat assembly from vehicle following procedure outlined under Seat Assembly Removal (Fig. 8 through 11).

(2)Lay seat assembly on its back on a clean sur-

face.

(3)Remove motor mounting screws.

(4)Carefully disconnect housing and cables from motor assembly.

INSTALLATION

(1) Place motor assembly into position.

(2)Carefully connect cables and housings to motor assembly.

(3)Install mounting screws.

(4)Install bolt holding motor assembly to adjuster.

(5)Install seat following procedure outlined under Seat Assembly Installation.

ENTHUSIAST SEAT

AG and AJ body vehicles have, as an option, a special enthusiast seat package. The seat includes not only the normal six-way power seat adjuster, but also special lumbar air filled support bag and adjustable seat back side wings (Fig. 12). These mechanisms are adjusted by a switch located on the right side seat wing. Refer to Owner Manual supplied with vehicle for complete instructions for seat operation.

SWITCH TEST

For switch testing, remove switch from its mounting location. Using an ohmmeter, refer to Figures 13 and 14 to determine if continuity is correct. If these results are not obtained, replace the switch.

SWITCH REPLACEMENT REMOVAL

(1)Remove left cushion side shield.

(2)Disconnect wiring from switch.

(3)Depress bezel retainers and push switch from

bezel.

(4)For installation, reverse above procedure.