- •I. Introduction
- •II. Quick Guide
- •III. Guitar Setup
- •IV. Pod Setup
- •V. Amp/Distortion Tone
- •VI. Cabs and Mics
- •I. Introduction
- •VIII. Tips and Pitfalls
- •IX. Troubleshooting Guide
- •X. Faq and Links
- •XI. Wish List
- •XII. Effects
- •XIII. Glossary
- •I. Frequency Response
- •XIII. Change Log Appendix a – Line 6 Effect Processing Diagrams Appendix b - Line 6 Effect Processing Table
- •I. Introduction
- •Section Overview
- •II. Quick Guide
- •I. Top Ten Tweaks
- •A. Quirks
- •Input Settings Global/Patch Option
- •Volume Knob/Ch. Vol. Functionality
- •Input 2
- •B. Patch-building Tips
- •C. High-Gain Amp Roundup
- •D. Cabs/Mics Roundup
- •F. Distortion Effects Roundup
- •G. Gain Staging
- •H. Eq Effects Roundup
- •I. Top Ten Tweaks
- •J. Killing Fizz
- •K. Mids for Metal
- •L. Dual Cab
- •M. Noise Gate Usage
- •P. Output Modes
- •Q. Input Settings
- •III. Guitar Setup
- •A. New Strings
- •B. String Gauge
- •C. Action
- •D. Fret Buzz
- •E. Intonation
- •F. Pickups
- •I. Single-Coil vs. Humbuckers
- •II. Pickup Position
- •III. Signal-to-Noise Ratio
- •IV. Frequency Response
- •V. Actives vs. Passives
- •VI. All about Blackouts
- •VII. Pickup Height on Passives
- •VIII. Pickup Height on Actives
- •IX. Pickup Suggestions
- •G. Bridge
- •I. Body/Fret board/Tuners/Neck-through/etc.
- •IV. Pod Setup
- •I. Simple Guide for Settings
- •II. Where Confusion Sets In
- •III. Global eq
- •A. Understanding Output Modes
- •I. Simple Guide for Settings
- •II. Where Confusion Sets In
- •III. Global eq
- •IV. Live-Voiced Cabs
- •V. Cab/Mic Simulation
- •VI. Bass Boost
- •VII. Output Mode Feature Chart
- •B. Internal Signal Routing
- •C. Running Direct (pa/board/computer or daw/monitors/headphones)
- •I. Simple method (no real amp)
- •II. Using a real amp as a pre-amp
- •D. Running to an amp ("live")
- •I. Amp without effects loop
- •II. Pod as Effects Only after pre-amp
- •III. Simple setup for amp with effects loop
- •IV. 4 Cable Method
- •E. I Tried This and It Doesn't Sound Good
- •F. Dual Output
- •G. Wet/Dry/Wet Output
- •H. Multiple Instruments/Independent Paths
- •I. Input Settings Global/Patch
- •Input 2
- •Impedance
- •J. The Effects (fx) Loop
- •K. The Mixer Block
- •L. Effects Order/Position
- •Noise Suppressors/Gates
- •Chorus/Phaser/Flanger
- •Delay/Reverb
- •Pitch Shifters
- •M. Gain Staging
- •I. Principles
- •II. Practice
- •V. Amp/Distortion Tone
- •A. Distortion Types/Overview
- •I. Frequency Chart
- •C. Gain Staging/Layering Distortions
- •D. High-Gain Amps
- •I. Park 75
- •II. Plexi Bright
- •IV. Uberschall
- •V. Dual Rectifier
- •VI. Fireball
- •VII. Elektrik
- •VIII. Dual Rectifier "Pre"
- •IX. Slo Overdrive
- •X. Doom
- •XI. Epic
- •E. Distortion Effects
- •I. Tube Drive
- •II. Screamer
- •III. Classic Distortion
- •IV. Overdrive
- •V. Facial Fuzz
- •VI. Line 6 Distortion
- •VII. Line 6 Drive
- •VIII. Others
- •F. Power Amp d.E.P.'s
- •G. Dual Amps
- •H. "Full" vs. "Pre"
- •I. The Elusive Pure Clean Tone
- •J. Noise Gates
- •VI. Cabs and Mics
- •I. Introduction
- •A. Cab/Mic Overview
- •Ignore General Frequency Response...
- •...Unless Frequencies are Missing
- •Response or Noise?
- •Using Res. Level to improve snr
- •Taming the Low End
- •Tonal Nuances
- •Dual Cabs
- •Using Cab/Mic Choices for eq Purposes
- •B. Cab Selection for Direct Tones
- •I. My Favorites
- •II. General Tips
- •III. Hiway 4x12
- •IV. Tread V-30 4x12
- •VI. Greenbacks 4x12
- •VII. Uber 4x12
- •VIII. Brit-t75 4x12
- •IX. Other cabs
- •C. Cab Selection for Live Tones
- •D. Mic Selection
- •I. Sm57 On/Off Axis
- •II. Dynamic Mics
- •III. Condenser Mics
- •IV. Ribbon Mics
- •E. Dual Cabs
- •I. Introduction
- •II. Getting the Patch Ready
- •III. Phase Correction
- •Cab/Mic Delay Times Matrix/alternate Google Cloud version/pdf version
- •IV. Eq'ing the tone
- •V. Other Amp Settings
- •VI. E.R. Settings
- •VII. Dsp Management
- •VIII. My Favorite Combinations
- •Res. Level
- •A. Classifying the Frequency Spectrum
- •B. How to eq a Hard Rock Tone
- •C. The Pod hd's eq Effects
- •I. Graphic eq
- •II. Parametric eq
- •III. Studio eq
- •IV. 4 Band Shift eq
- •VI. Q Filter
- •D. Eq'ing your Patch
- •E. Fizzy Spots
- •VIII. Tips and Pitfalls
- •A. Tone Matching
- •B. Branching/Evolving Patches
- •C. Setlist Tips
- •D. Effect Switching/Tips
- •E. Recording Tips
- •F. Monitoring
- •G. Dsp Allocation/Advice
- •H. Mesa Boogie Mark II/IV tone
- •I. Clean Boost
- •J. Leveling Patches
- •K. Clarifying Confusing Volume Controls
- •I. The Pad Switch
- •II. The master Knob
- •III. Amp/Channel Volume aka volume Knob
- •IV. Mixer Levels
- •V. Master d.E.P.
- •L. Clipping
- •I. Input Clipping
- •II. Signal Clipping
- •III. Effects Clipping
- •IV. Clipping external devices
- •V. "Digital Clipping" (Crossover Distortion) on "Full" Amp Models
- •M. Bad Monitoring
- •I. Acoustic Tone
- •II. Bad Monitors
- •III. Bad Room
- •IV. Low Volume
- •N. Wrong Output Mode
- •O. Gain Staging
- •P. Outside vs. Inside Mix
- •Q. Relying on Others' Patches
- •IX. TroubleShooting
- •A. Too much noise
- •B. Tone is fizzy/noisy
- •C. Tone is harsh
- •D. Tone has digital clipping
- •E. Tone is muffled
- •F. Distortion is muddy/fuzzy/farty
- •G. Distortion is dirty/gritty
- •H. Tone is thin
- •I. Software Knobs move on their own
- •J. I'm Getting dsp Limit Reached Errors
- •X. Faq and Links
- •A. Frequently Asked Questions
- •I. Tone
- •Is the tone better when using Input 2: Variax (or another unused input)?
- •Should I use "full" or "pre" amp models?
- •Where should I set the master knob?
- •What does the Master dep do for amps models where there was no master volume on the original?
- •II. Output/Routing Can I output dual output modes with the hd-500 or Pro?
- •Can I output w/d/w (wet/dry/wet)?
- •Can I reamp over usb?
- •Why can't I get any output from Channel b?
- •Why don't I have stereo output?
- •III. Usage How Should I Level my Patches?
- •Why can't I get a natural volume swell with the Exp. Pedal?
- •How do I use the Pitch Glide?
- •IV. Compatibility/Hardware Does the Pod hd work with Gearbox?
- •Can I use hd-XXX patches on hd-yyy?
- •What is the differences between the Pod hd models?
- •Can I use a different power adapter?
- •Can I modify my Pod hd to gain more dsp power?
- •Do you take tone requests?
- •B. Links
- •I. General
- •II. Forums
- •III. Pod hd References
- •B. Amps
- •C. Utilities
- •D. Routing
- •F. Footswitches/controls/Midi
- •G. Effects
- •H. Dsp Saving Features
- •I. Devkit
- •XII. Effects
- •A. Preferred Effects
- •I. Chorus
- •II. Flanger
- •III. Compressors
- •IV. Reverb
- •V. Delay
- •B. Dialing in the Flangers
- •C. Substitutes
- •D. Ordering
- •XIII. Glossary
- •I. Frequency Response
- •A. Signal-Based Terms
- •I. Clipping
- •II. Distortion
- •III. Signal
- •IV. Noise
- •V. Signal-to-Noise Ratio (snr)
- •VI. Impedance
- •VII. Signal Chain
- •VIII. Mono
- •IX. Stereo
- •X. Field
- •XI. Balance
- •I. Frequency Response
- •VII. Shelf
- •VIII. Peak/Valley
- •II. Fizz
- •III. Buzz
- •IV. Grinding
- •V. Crunchy
- •VI. Chunky/Punchy
- •VII. Fuzzy
- •VIII. Cold
- •IX. Warm
- •XIV. Change Log
- •Appendix a – Line 6 Effect Processing Diagrams
- •Appendix b - Line 6 Effect Processing Table
- •Appendix c – Cabinet/Mic Phase Correction Timing Data
- •Appendix d – dsp Usage of Effects
F. Distortion Effects Roundup
For more detail on distortion effects, see the Distortion/Amp Tone Page.
Line 6 Drive
Probably the best all-around Distortion effect. The distortion tone is great - not too much bite or anything off-putting about it. And for using it to EQ the tone, the Mids parameter acts as a center frequency, not a boost/cut. This lets you dial in the specific center frequency you want to boost an amp with.
Tube Drive
This is probably the most natural-sounding distortion effect. It basically adds an extra gain-stage to whatever amp you're using, although it can produce a nice distortion all on its own. I use it in front of a Plexi, and with various settings, this produces good Rhoads, Slash, and EVH tones. It has decent headroom, so you can use it as a basic compressor. It has bass/mids/treble controls that make it a good filter for pre-EQ'ing.
Screamer
Similar to the Tube Drive, it makes a good pre-EQ choice. I don't use it as a standalone distortion. It has a unique frequency response and compression that makes it ideal for modern metal - you get a djenty presence from it. It won't get 100% clean even at 0% drive, but its dirt tends to get incorporated into the distortion tone of whatever amp you feed it into. It's also a bit scratchier and colder than the Tube Drive.
Classic Distortion
This can sometimes makes a good pre-EQ filter, but is difficult to control on the bass side, often coming out too scooped. The Filter control requires experimentation to understand. The Treble control seems to affect very high frequencies and things can get harsh when boosted. I try to keep it at 50%. It will get clean at 0% Drive, and makes a decent compressor. I prefer to use the Tube Drive as a standalone distortion. I would try this out where the Tube Drive and Screamer just aren't working for some reason.
Line 6 Distortion
I use this as a standalone distortion, when I want a very tight, very distorted tone, similar to a Boss Metal Zone. I'll actually pre-EQ this effect, to dial in exactly the distortion I want. In this sense, it's like having an additional high-gain amp, but you have to pair it with the right amp to get a good tone out of it. I like the Park 75, as it seems to deliver a more natural frequency response than some other amps. Also the Divided by 13 works well.
Overdrive
I actually like to use this for a standalone distortion. Pre-EQ'ing a little bass in front gives it a nice warm fuzz tone, and it's not wonky like a lot of the other fuzzes.
Facial Fuzz
I use this as a part boost/part standalone distortion into a Plexi for a Hendrix tone. It's got that strange dynamic response you need for that kind of tone. By itself it's a bit much for my tastes. As a filter with mild gain, it's not really doing that much. I use medium gain and output, and let the Plexi add its distortion flavor on top the response.
Others
The others sound too wonky to me. The Muff in particular sounds like you're playing through damaged electronics, but maybe I'm just not using it right.
Top of Quick Guide
