Добавил:
Upload Опубликованный материал нарушает ваши авторские права? Сообщите нам.
Вуз: Предмет: Файл:
FWD / 92FWD_23.PDF
Источник:
Скачиваний:
69
Добавлен:
19.03.2015
Размер:
5.12 Mб
Скачать

23 - 102 AP-BODY

 

Ä

 

(2) When the weatherstrip has been installed down the door opening to the sill pinch flange, mate the ends of the weatherstrip together and finish installing.

Fig. 27 Door Opening WeatherstripsÐTypical

QUARTER GLASS WINDOW

REMOVAL (FIG. 28)

(1)Remove quarter trim panel as necessary to gain access to quarter glass fasteners.

(2)Remove quarter window opening moulding.

(3)Remove screw holding quarter glass to retaining bracket.

(4)Remove rivets holding quarter glass to B-pillar with a 6 mm (0.250 in.) drill.

INSTALLATION

Reverse the preceding operation.

Fig. 28 Quarter GlassÐAP-24 Body

QUARTER GLASS WEATHERSTRIP

REMOVAL (FIG. 29)

(1) Remove quarter trim panel as necessary to gain access to quarter glass fasteners.

(2)Remove screw holding quarter glass to retaining bracket.

(3)Hinge quarter glass away from weatherstrip.

(4)Remove quarter glass weatherstrip from pinch flange.

INSTALLATION

Reverse the preceding operation.

Fig. 29 Quarter Glass WeatherstripÐAP-24 Body

BODY SIDE MOULDING AND APPLIQUE

STICK-ON BODY SIDE MOULDING REMOVAL AND INSTALLATION

(1)Warm the effected stick-on moulding and body metal to approximately 38°C (100°F) using a suitable heat lamp or heat gun.

(2)Pull stick-on moulding from painted surface.

(3)Remove adhesive tape residue from painted surface of vehicle.

(4)If moulding is to be reused, Remove tape residue from moulding. Clean back of moulding with Mopar, Super Kleen solvent or equivalent. Wipe moulding dry with lint free cloth. Apply new body side moulding (two sided adhesive) tape to back of moulding.

(5)Clean body surface with Mopar, Super Kleen solvent or equivalent. Wipe surface dry with lint free cloth.

(6)Apply a length of masking tape on the body, parallel to the top edge of the moulding to use as a guide, if necessary.

(7)Remove protective cover from tape on back of moulding. Apply moulding to body below the masking tape guide.

(8)Remove masking tape guide and heat body and moulding, see step one. Firmly press moulding to body surface to assure adhesion.

Соседние файлы в папке FWD