Добавил:
Upload Опубликованный материал нарушает ваши авторские права? Сообщите нам.
Вуз: Предмет: Файл:
FWD / 92FWD_23.PDF
Источник:
Скачиваний:
69
Добавлен:
19.03.2015
Размер:
5.12 Mб
Скачать

Ä

 

AP-BODY 23 - 101

 

(2)Remove door glass.

(3)Remove screws holding belt moulding and weatherstrip to outer door panel and separate moulding from door.

INSTALLATION

Reverse the preceding operation.

REAR DOOR GLASS RUN WEATHERSTRIP

REMOVAL

(1)Remove door belt moulding and weatherstrip assembly.

(2)Pull door glass run weatherstrip from forward lower channel and upper door frame.

(3)Separate glass run weatherstrip from door.

INSTALLATION

(1)Insert glass run weatherstrip into top of glass opening upper channel. Align molded corner of weatherstrip to upper front corner of glass opening.

(2)Push weatherstrip into door frame window opening.

(3)Install door belt moulding and weatherstrip assembly.

REAR DOOR STATIONARY GLASS

STATIONARY GLASS REMOVAL

(1)Remove belt moulding and weatherstrip assem-

bly.

(2)Remove upper window opening moulding.

(3)Remove bolts and screws holding division channel and glass module to door assembly and separate division channel from door frame.

(4)Separate stationary glass from division channel.

(5)Remove division channel through opening at top of door.

STATIONARY GLASS INSTALLATION

Reverse the preceding operation.

REAR DOOR WINDOW REGULATOR/MANUAL

MANUAL WINDOW REGULATOR REMOVAL (FIG. 26)

(1)Remove trim panel, silencer pad, and water shield.

(2)Position door glass 150 mm (6 in.) up into glass opening.

(3)Remove bolts holding window regulator to inner door panel.

(4)Slide roller from window lift channel.

(5)Remove bolts holding reinforcement brace to inner door panel.

(6)By hand, pull glass upward to 25 mm (1 in.) from full up position. Using suitable tape, secure door glass to upper window frame.

(7) Remove regulator assembly from door.

MANUAL WINDOW REGULATOR

INSTALLATION

Reverse the preceding operation.

Fig. 26 Rear Door Manual Window

RegulatorÐTypical

REAR DOOR WINDOW REGULATOR/POWER

POWER WINDOW REGULATOR REMOVAL

(1)Remove trim panel and water shield.

(2)Position door glass 150 mm (6 in.) up into glass opening.

(3)Remove bolts holding window regulator lift bracket to door glass.

(4)Remove fasteners holding power window regulator to inner door panel.

(5)By hand, pull glass upward to 25 mm (1 in.) from full up position. Using suitable tape, secure door glass to upper window frame.

(6)Remove regulator assembly from door.

POWER WINDOW REGULATOR INSTALLATION

Reverse the preceding operation.

DOOR OPENING WEATHERSTRIPS

FRONT OR REAR DOOR OPENING WEATHERSTRIP REMOVAL (FIG. 27)

(1)Remove interior trim as necessary to gain access to door opening weatherstrip.

(2)Pull weatherstrip from pinch flange around door opening.

FRONT OR REAR DOOR OPENING

WEATHERSTRIP INSTALLATION

(1) Locate the middle to the weatherstrip at the center of the upper pinch flange. Push weatherstrip onto pinch flange at the top corner near the B-pillar.

Соседние файлы в папке FWD