23 - 96 AP-BODY

FRONT DOOR GLASS

REMOVAL (FIG. 13)

(1)Remove door trim panel, silencer pad, and water shield.

(2)Position door glass half way up in door glass opening.

(3)Insert door glass removal tool C-4867 between the glass slide and channel retaining lip at approximately 50 mm (2 in.) down from top rearward corner of glass. Push handle of tool toward glass to open channel. Push downward at the front of the glass to separate the slide from the channel.

(4)Insert door glass removal tool C-4867 between the glass slide and channel retaining lip at approximately 50 mm (2 in.) up from bottom rearward corner of glass through opening in inner door panel. Push handle of tool toward glass to open channel. Pull upward at front of glass to separate the slide from the channel. Do not allow upper slide to snap bank into channel.

(5)Rotate front of glass downward and slide glass forward to separate glass lift channel from regulator lift arm roller.

(6)Remove door glass through opening at top of

door.

INSTALLATION

(1)Lower door glass into opening at top of door.

(2)Tip rear of glass downward and insert window regulator lift arm roller into glass lift channel.

(3)Guide door glass into glass run weatherstrip at front of door.

(4)Push top of glass rearward to snap top slide into glass run channel.

(5)Push downward at front of glass to snap bottom slide into glass run channel.

(6)Install water shield, silencer pad and trim panel.

FRONT POWER DOOR LOCK ACTUATOR

REMOVAL (FIG. 14)

(1)Disconnect battery negative cable.

(2)Remove front door trim panel.

(3)Remove water shield as necessary.

(4)Remove rivets holding lock motor to inner door panel with a 6 mm (1/4 in.) drill.

(5)Disconnect lock motor linkage rod from door

latch.

(6)Disconnect lock motor wire connector.

(7)Separate lock motor from door.

INSTALLATION

Reverse the preceding operation.

Ä

Fig. 13 Front Door Glass

Fig. 14 Front Power Door Lock ActuatorÐTypical

FRONT DOOR BELT MOULDING AND

WEATHERSTRIP

BELT MOULDING AND WEATHERSTRIP REMOVAL

(1)Remove trim panel, silencer pad, and water shield as necessary to gain access to belt moulding attaching screws.

(2)Remove door glass.

(3)Remove screws holding belt moulding and weatherstrip to outer door panel and separate moulding from door.

BELT MOULDING AND WEATHERSTRIP INSTALLATION

Reverse the preceding operation.