Добавил:
Upload Опубликованный материал нарушает ваши авторские права? Сообщите нам.
Вуз: Предмет: Файл:
FWD / 92FWD_23.PDF
Источник:
Скачиваний:
69
Добавлен:
19.03.2015
Размер:
5.12 Mб
Скачать

23 - 56 AG-BODY

 

Ä

 

mm (0.240 in) gap to front door edge. All surfaces across gaps should be flush.

Fig. 11 Front Fender

DOOR TRIM PANEL

REMOVAL (FIG. 12)

(1)Lower door glass to down position. Disconnect battery negative cable, if equipped with power windows.

(2)Remove window crank screw cover. Remove screw holding window crank to regulator and separate crank from door, if equipped with manual windows.

(3)Remove screw holding inside latch release handle bezel to door. Slide bezel forward and remove from door panel. Disconnect power door lock switch wire connector, if equipped.

(4)Pull power mirror switch outward to disengage clips holding switch to door panel. Disconnect mirror switch wire connector, if equipped.

(5)Lift upward at rear edge of power window/seat switch bezel to disengage clips holding bezel to door panel. Disconnect wire connectors from power window and power seat switches, if equipped.

(6)Remove screw holding trim panel to door from inside power window switch bezel opening.

(7)Pry outward on reflector lens to disengage clips. Remove screw holding trim panel to door from behind reflector.

(8)Remove hidden screws holding trim panel to door from carpet area on trim panel.

(9)Disengage push-in fasteners holding trim panel to door at ends and bottom center of trim panel.

(10)Lift trim panel from door.

INSTALLATION

Reverse the preceding operation.

Fig. 12 Door Trim Panel

FRONT DOOR SILENCER AND WATER SHIELD

REMOVAL (FIG. 13)

(1)Remove front door trim panel.

(2)Remove push-in fasteners holding silencer pad to door inner panel and separate silencer from door.

(3)Pull water shield from adhesive around perimeter of door inner panel.

INSTALLATION

Reverse the preceding operation.

Fig. 13 Front Door Silencer and Water

ShieldÐTypical

FRONT DOOR AND HINGE

The front door hinge is welded to the door and bolted to the hinge pillar. The door half of the hinge pivots on a removable hinge pin. The hinge pin is driven in from the bottom on the top hinge and from the top on the bottom hinge. All adjustments to the hinge are performed on the hinge pillar half of the hinge. If the welded half of the hinge must be bent to align door, consult an authorized body repair facility.

Соседние файлы в папке FWD