Добавил:
Upload Опубликованный материал нарушает ваши авторские права? Сообщите нам.
Вуз: Предмет: Файл:
FWD / 92FWD_23.PDF
Источник:
Скачиваний:
68
Добавлен:
19.03.2015
Размер:
5.12 Mб
Скачать

Ä

(11)Shift the front of head lining to one side to pull head lining from behind B-pillar trim. Pull head lining from behind other B-pillar trim.

(12)Allow front of head lining to drop downward. Slide head lining forward from behind quarter panel trim.

(13)Remove head lining from vehicle.

INSTALLATION

Reverse the preceding operation.

Fig. 48 Head Lining

SUN ROOF WEATHERSTRIP

REMOVAL (FIG. 49)

(1)Remove sun roof sunshade and glass. Refer to Owner's Manual for instructions.

(2)Pull weatherstrip from pinch flange around sun roof opening.

INSTALLATION

Reverse the preceding operation.

SUN ROOF AIR DEFLECTOR

REMOVAL (FIG. 49)

(1)Remove sun roof sunshade and glass. Refer to Owner's Manual for instructions.

(2)Disengage snap-on linkage at rear of air deflector in sun roof opening.

(3)Remove screws holding air deflector to front of sun roof opening.

INSTALLATION

Reverse the preceding operation.

AA-BODY 23 - 31

SUN ROOF DRAIN TUBES

REMOVAL (FIG. 49)

(1)Remove head lining as necessary.

(2)Remove A-pillar or B-pillar trim covers as necessary.

(3)Remove cowl panel and sill plate trim as neces-

sary.

(4)Disconnect effected drain tube from nipple at sun roof opening.

(5)Pull drain tube upward to remove from pillar involved.

INSTALLATION

Reverse the preceding operation. Route the tube to avoid kinks or puncture from sharp edges.

VINYL ROOF BONNET

REMOVAL (FIG. 50)

(1)Remove quarter panel trim covers.

(2)Remove head lining.

(3)Remove nuts holding transverse roof moulding to roof panel and separate moulding from vehicle.

(4)Remove nuts holding vinyl top bonnet to roof.

(5)Remove rear deck filler panel.

(6)Remove screws holding rear window opening lower valance to body.

(7)Disengage hook and loop fasteners holding vinyl top bonnet to quarter panels.

(8)Pull vinyl top bonnet away from top panel to separate bonnet from anti-flutter sealer holding bonnet to roof.

INSTALLATION

(1)Clean anti-flutter sealer from roof surface and inside of vinyl roof bonnet.

(2)Apply a 20 mm (0.75 in.) bead of anti-flutter sealer across the roof panel at the mid point between the front of the bonnet and rear of roof.

(3)Apply a 20 mm (0.75 in.) by 150 mm (6 in.) bead of anti-flutter sealer down each roof side panel at mid point between the door opening and rear of roof.

(4)Place the bonnet into position on the roof panel and align to proper fit.

(5)Reverse the removal operation.

REAR DECK FILLER PANEL

REMOVAL (FIG. 51)

(1)Raise truck lid to full up position.

(2)Remove screws holding rear deck filler panel to body in the front trunk opening gutter.

(3)Close trunk lid, do not latch.

(4)Lift filler panel upward and separate from ve-

hicle.

Соседние файлы в папке FWD