23 - 22 AA-BODY

REAR POWER DOOR LOCK ACTUATOR

REMOVAL (FIG. 30)

(1)Remove door trim panel, silencer pad, and water shield.

(2)Raise door glass to full up position.

(3)Remove door speaker, if equipped.

(4)Disconnect actuator rod from door latch assem-

bly.

(5)Remove screws holding power lock actuator to inner door panel and separate from door.

INSTALLATION

Reverse the preceding operation.

Fig. 30 Rear Power Lock Actuator

REAR DOOR GLASS

REMOVAL (FIG. 31)

(1)Remove door trim panel, silencer pad, and water shield.

(2)Position door glass half way up in door glass opening.

(3)Pull upward firmly at the front upper corner of glass to disengage lower glass guide from run channel.

(4)Insert door glass removal tool C-4867 between the glass slide and division run channel retaining lip at approximately 50 mm (2 in.) down from top rearward corner of glass. Push handle of tool toward glass to open channel. Pull forward on the glass to separate the slide from the channel.

(5)Position glass inboard of the division channel. Pivot top of glass rearward between division channel and inner door panel.

(6)Separate regulator lift arm roller from glass lift channel. Hold regulator lift arm outward and lift glass upward.

(7)Remove door glass through opening at top of

door.

Ä

INSTALLATION

(1)Lower door glass into opening at top of door.

(2)Insert window regulator lift arm roller into glass lift channel.

(3)Push top of glass rearward to snap top slide into division run channel.

(4)Push downward at front of glass to snap bottom slide into channel.

(5)Install water shield, silencer pad and trim panel.

Fig. 31 Rear Door Glass

REAR DOOR BELT MOULDING AND WEATHERSTRIP

BELT MOULDING AND WEATHERSTRIP REMOVAL (FIG. 32)

(1)Remove trim panel, silencer pad, and water shield.

(2)Remove door glass.

(3)Remove screws holding belt moulding and weatherstrip to outer door panel and separate moulding from door.

BELT MOULDING AND WEATHERSTRIP INSTALLATION

Reverse the preceding operation.

REAR DOOR GLASS RUN WEATHERSTRIP

REMOVAL (FIG. 33)

(1)Remove door belt moulding and weatherstrip assembly.

(2)Pull door glass run weatherstrip from forward lower channel and upper door frame back to division channel.