Добавил:
Upload Опубликованный материал нарушает ваши авторские права? Сообщите нам.
Вуз: Предмет: Файл:
FWD / 92FWD_23.PDF
Источник:
Скачиваний:
69
Добавлен:
19.03.2015
Размер:
5.12 Mб
Скачать

23 - 14 AA-BODY

TRANSAXLE SPLASH SHIELD REMOVAL (FIG. 7)

(1)Remove one front wheelhouse splash shield push-in fastener and separate wheelhouse splash shield from transaxle splash shield.

(2)Remove transaxle splash shield attaching bolts and separate transaxle splash shield from vehicle.

TRANSAXLE SPLASH SHIELD INSTALLATION

Reverse the preceding operation.

ENGINE DRIVE BELT SPLASH SHIELD REMOVAL (FIG. 8)

(1)Hoist vehicle and support on suitable safety stands.

(2)Remove bolts holding engine drive belt splash shield to right frame rail.

(3)Separate drive belt splash shield from vehicle.

ENGINE DRIVE BELT SPLASH SHIELD INSTALLATION

Reverse the preceding operation.

Fig. 8 Engine Drive Belt Splash Shield

FRONT FENDER

REMOVAL (FIG. 9)

(1)Remove front side marker lamp assembly. Refer to Group 8L, Lamps for instructions.

(2)Remove front bumper as necessary to gain clearance to remove front fender. Refer to Front Bumper Removal paragraph in this section.

(3)Remove front wheelhouse splash shield. Refer to Front Wheelhouse Splash Shield Removal paragraph of this section.

(4)Remove rocker panel moulding as necessary to clear front fender. Refer to Body Side Moulding and Applique Removal paragraph in this section.

(5)Remove bolts holding bottom front fender at rear of wheel opening.

(6)Remove bolt holding front fender at rear of wheelhouse.

Ä

(7)Remove bolt holding front fender at top of front door opening.

(8)Remove bolts holding front fender to front lower brace and under radiator closure panel.

(9)Remove bolts holding front fender to front of radiator closure panel.

(10)Raise hood and support hood on a suitable holding device. Mark hinge for installation indexing. Remove lower hood hinge attaching bolts and separate hinge from front fender. Refer to Hood Hinge Removal paragraph in this section.

(11)Remove bolts holding front fender to inner wheelhouse along hood opening.

(12)Separate front fender from vehicle.

INSTALLATION

Reverse the preceding operation. Align front fender to achieve a 4 mm (0.160 in) gap to hood edge and 6 mm (0.240 in) gap to front door edge. All surfaces across gaps should be flush.

Fig. 9 Front Fender Assembly

FRONT DOOR TRIM PANEL

DOOR TRIM PANEL WITH POWER WINDOWS REMOVAL (FIG. 10)

(1)Move glass to down position.

(2)Disconnect battery negative cable.

(3)Using a suitable prying tool, lift upward at front of power window switch bezel and disengage bezel from clip in door panel. Disconnect wire connector from back of switch.

(4)Remove door latch handle bezel insert. Disconnect power door lock switch wire connector, if equipped. Remove screws holding handle bezel to trim panel and separate bezel from door.

(5)Remove screw holding armrest pull handle to door through door latch handle bezel opening.

(6)Remove hidden screw from in carpet at rear lower corner of trim panel.

(7)Using a suitable trim clip tool, disengage frog leg clips at the ends and bottom of trim panel. After

Соседние файлы в папке FWD