Fig. 9 Match Socket to Outer Seal Diameter

Fig. 10 Installing Seal

(12) Install felt shaft seal and retainer (Fig. 13) into front housing.

Caution: Refer to Oil Level in the Refrigerant Service Procedures section for further details.

(13)Install refrigeration oil (500 SUS) into the compressor through the suction port.

(14)Check compressor operation for smoothness by rotating crankshaft at least five full revolutions.

Fig. 11 Seal Snap Ring

Fig. 12 Installing Lip Seal Protector

(15)Check front housing clutch coil alignment pin for proper installation.

(16)Install clutch assembly.

(17)Install compressor.

(18)Evacuate and charge refrigerant system.

COMPRESSOR HIGH-PRESSURE RELIEF VALVE

REMOVAL AND INSTALLATION

(1)Discharge the refrigerant system.

(2)Rotate the high pressure relief valve counterclockwise and separate relief valve from the vehicle (Fig. 14).

To install, Reverse the preceding operation using a new O-ring seal. Evacuate and charge the refrigerant system.