Примеры брендбуков / Huindai / hyundai
.pdfThe fascia ratio should be selected with consideration to the surrounding environment. The spacing and positioning of the logo and descriptors must be in accordance with the following rules.
Typography
Dealer name : Univers Bold / Condensed 90%
Specifications
Panaflex
Surface treatment : Apply cut sheets
3M 3630-121(PMS 877C)
3M 3630-157(PMS 288C) Illuminated sign : Fluorescent light
Note : Please use 3M film 3M 3630-121(PMS 877C) / 3M 3630-157(PMS 288C) for illuminated signs.
Installing the standard fascia is ideal.
However, if the area is too small to support the standard fascia, variations smaller than 1:8 as shown below may be used.
The fascia ratio should be selected with consideration to the surrounding environment. The spacing and positioning of the logo and descriptors must be in accordance with the following rules.
Specifications
Panaflex
Surface treatment : Apply cut sheet
3M 3630-121(PMS 877C) /
3M 3630-157(PMS 288C) Illuminated sign : Fluorescent light
The ratio of length and width greater than 1:20
The ratio of length and width greater than 1:20
Here are the examples of fascia module of which the ratio of length and width is greater than 1:20.
The fascia design should be selected with consideration to the building structure.
Use fascia variations if one of the two sides is equal to or smaller than 1:8
Example for use of fascia variation on two sides
Use fascia variations if one of the three sides is equal to or smaller than 1:8
Example for use of fascia variation on three sides
Projecting signs communicate to pedestrians and drivers the location of Hyundai Motor Company dealer shops, and therefore they must project a consistent and coherent image.
Only use the ratios illustrated below.
* Please refer to the next page.
The projecting sign ratio should be selected with consideration to the surrounding environment. The spacing and positioning of the logo and descriptors must be in accordance with the following rules.
Typography
Dealer Name: Univers Bold / Condesed 90%
Specifications
Panaflex
Surfaces treatment : Apply cut sheets
3M 3630-121(PMS 877C)
3M3630-157(PMS 288C) Illuminated signs : Fluorescent light
The ratio of width and height less than 1:3.
The variation of ratio of width and height greater than 1.5:1 is not recommended.