Fig. 9 Servicing Fuel Injector

INSTALLATION

(1)Apply a light coating of clean engine oil on the O-rings.

(2)Place assembly in the pod. Align the injector wiring terminals with the injector cap fastener hole (Fig. 10).

Fig. 10 Fuel Injector Installation

(3)Install injector cap with locating notch aligned with the locating lobe on the injector (Fig. 11).

(4)Push down on the cap to ensure a good seal.

(5)Rotate the cap and injector to line up the attachment hole (Fig. 12).

(6)Install injector cap holddown screw (torx-head screw). Tighten screw to 4-5 NIm (35-45 in. lbs.) torque.

(7)Connect negative cable to battery.

CAUTION: When using the ASD Fuel System Test, the Auto Shutdown (ASD) Relay remains energized

Fig. 11 Installing Fuel Injector Cap

Fig. 12 Fuel Injector Installed

for either 7 minutes, until the test is stopped, or until the ignition switch is turned to the Off position.

(8)With the ignition key in ON position, access the DRB II ASD Fuel System Test to pressurize the fuel system. Check for leaks.

(9)Reinstall the air cleaner assembly.

THROTTLE POSITION SENSOR

REMOVAL

(1)Disconnect negative cable from battery.

(2)Remove air cleaner.

(3)Disconnect harness connector from throttle position sensor (Fig. 13).

(4)Remove throttle position sensor mounting screws.

(5)Remove throttle position sensor from throttle

shaft.

INSTALLATION

(1) Install throttle position sensor to throttle body, position toward the front of the vehicle. Tighten screws to 2 NIm (20 in. lbs.) torque.