Ä

(3) Working from the engine compartment, remove nuts from accelerator pedal assembly studs (Fig. 1). Remove assembly from vehicle.

INSTALLATION

(1)Position accelerator pedal assembly on dash

panel. Install retaining nuts. Tighten retaining nuts to 12 NIm (105 in. lbs.) torque.

(2)From inside the vehicle, hold up the pedal and install the throttle cable and cable retainer in the upper end of the pedal shaft.

(3)From the engine compartment, hold the throttle body lever in the wide open position and install the throttle cable.

THROTTLE CABLE

REMOVAL

(1)Working from the engine compartment, hold throttle lever in the wide open position and remove the throttle cable from the throttle body cam (Fig. 3, 4, 5, 6 and 7).

(2)From inside the vehicle, hold the throttle pedal up and remove the cable retainer and cable from upper end of pedal shaft (Fig. 1 and Fig. 2).

Fig. 3 Throttle Cable Attachment to Throttle BodyÐTBI Engine

FUEL SYSTEMS 14 - 15

(3)Remove retainer clip from throttle cable and grommet at the dash panel (Fig. 2).

(4)From the engine compartment, pull the throttle cable out of the dash panel grommet. The grommet should remain in the dash panel.

(5)Remove the throttle cable from the throttle bracket by carefully compressing both retaining tabs simultaneously. Gently pull throttle cable from throttle bracket.

INSTALLATION

(1) From the engine compartment, push the housing end fitting into the dash panel grommet.

Fig. 5 Throttle Cable Attachment to Throttle BodyÐTurbo III Engine