Добавил:
Sekretar
kiopkiopkiop18@yandex.ru
t.me/Prokururor I Вовсе не секретарь, но почту проверяю
Опубликованный материал нарушает ваши авторские права? Сообщите нам.
Вуз:
Предмет:
Файл:Ординатура / Хирургия / Библиотека им академика М.И. Перельмана / Книга_3749_Библиотеки_им_академика_М_И_Перельмана
.pdf
1 Basic Arterial Techniques
9
Fig. 1.11 Proximal end-to-end anastomosis between the infrarenal aorta to the Dacron graft.
Aortotomy is spatulated anteriorly. Posterior suture line is started rst in a continuous manner
using both needles, continued on each side, and completed on either side
Types ofGrafts toArtery Anastomosis
Two types of anastomosis, end to end and end to side, are most often performed in
construction of artery-to-graft anastomosis. Side-to-side anastomosis are occasionally performed for construction of the arteriovenous stula for hemodialysis access
or as an adjunct to infragenicular prosthetic bypass at the site of distal anastomosis
to help improve the patency of the synthetic graft.

10
S. S. Hans
End-to-End Anastomosis
A typical end-to-end anastomosis of a large vessel is exemplied in the arterial
reconstruction following open repair of abdominal aortic aneurysm (AAA). The end
of the divided aorta below the renal arteries is anastomosed to a prosthetic graft
(Dacron or PTFE). After proximal control is obtained, the anterior wall of the aortic
neck is divided, and the posterior wall can be left intact. The posterior wall of the
aorta can be used as a double layer to buttress the suture line. In patients with satisfactory thickness of the aortic neck, the continuous suture starting intraluminal at 4
o’clock position is started. A double-armed 3-0 cardiovascular polypropylene suture
is started in a continuous fashion with the suture line kept on loops (strings of a
parachute) and the needle comes out in about 8 o’clock position. The suture line is
then tightened on each side to bring the graft to the aortic neck. To avoid accidental
loosening of the suture line, a new suture is tied to the rst one on either side at 4
o’clock and at 8 o’clock and continued anteriorly. In patients with tenuous aortic
neck or in patients with juxtarenal abdominal aortic aneurysm, a two-layer anastomosis is performed with two techniques. (1) In patients with juxtarenal abdominal
aortic aneurysms, the initial suture line is started at 3 o’clock and at 9 o’clock as
horizontal mattress suture and continued anteriorly in the same fashion. And a second layer of a continuous over and over suturing is done. (2) In patients with weak
and tenuous aortic neck or in patients with juxtarenal AAA, a two-layer anastomosis
is performed with two techniques. Technique one is telescoping technique in
patients with juxtarenal AAA.Technique two consists of interrupted sutures and a
second with continuous suture. In patients with thin-walled and friable aortic neck,
the rst layer comprises of interrupted horizontal mattress.
End-to-Side Anastomosis
A technique to end-to-side attachment to a prosthetic graft to the artery is shown in
Figs.1.9, 1.10, 1.11, and 1.12. The length of the arteriotomy is about two and a half
times the diameter of the graft. After arteriotomy is made, the prosthetic graft is cut
in a lazy “S”-shaped manor to produce a wide anastomosis with diminished chance
of turbulence and intimal hyperplasia. The anastomosis is started at the heel using a
double-armed suture at 11:30’ and 12:30’clock position, and suture line continued
on each side with suture line stopping around 8 o’clock and then the second suture
is continued to complete the suture line (Figs.1.12, 1.13, and 1.14). Before completing the anastomosis, appropriate ushing maneuvers are performed to prevent
distal embolization. In patients with end-to-side saphenous vein anastomosis to the
common femoral artery, the hood of the greater saphenous vein (in situ technique)
is spatulated, and a parachute technique is used to ensure the accuracy of the placement of all the sutures. In patients undergoing subclavian transposition into the

1 Basic Arterial Techniques
Fig. 1.12 Dacron graft cut
with a heavy scissors in a
lazy “S” shape for
end-to-side femoral
anastomosis of the
aortofemoral graft
Fig. 1.13 Arteriotomy and
cut Dacron graft
11
Fig. 1.14 End-to-end
anastomosis

12
S. S. Hans
common carotid artery, an end-to-side anastomosis is performed with suturing starting on the posterior wall in a continuous fashion using a parachute technique and
turning the corners of a continuous suturing on either side of the arteriotomy. A
similar technique is used when planting the inferior mesenteric artery as a carrel
patch to the prosthetic graft during open AAA repair. In these situations, an ellipse
of the recipient artery/graft is removed with either curved Potts scissors or an arterial punch. Patch grafting is often necessary following carotid endarterectomy or
performance of any arteriotomy where suture line closure may result in narrowing
of the artery. Bovine pericardial patch (Edward Lifesciences) is frequently used as
it is quite soft and pliable and the needle holes do not bleed excessively as observed
with the use of PTFE patch.
Endarterectomy
Endarterectomy is a common procedure performed for open arterial reconstructions. Endarterectomy can be performed as an isolated procedure such as a carotid
endarterectomy or as in common femoral endarterectomy. It can also be performed
in conjunction with arterial bypass grafting. The strongest arterial layer is adventitia, and the atheromatous plaque is primarily located in the subintimal plane and
involves variable thickness of media. The most satisfactory plane of dissection leaving the adventitia is lined by the external elastic membrane (Fig.1.15). These circular bers of media should be removed in patients undergoing carotid endarterectomy.
In patients undergoing femoral endarterectomy, circular bers of the media can be
left if there are formerly adherent, and removal of these bers may result in severe
thinning of the arterial wall. There are essentially three methods for used for endarterectomy: (1) open, (2) semi closed, and (3) eversion.
Fig. 1.15 Transverse
section of the artery
showing the plane of
endarterectomy

1 Basic Arterial Techniques
13
Open Endarterectomy
The classical example of open endarterectomy is carotid endarterectomy. This procedure is more suitable for short-segmented lesions. The arteries open longitudinally after primary and distal clamping following administration of systemic
heparin. A cleavage plane is developed between the thickest part of the plaque and
the adventitia with the help of arterial dissector (dural elevator) and continued distally till the plaque ends in a feathery end (Figs.1.16, 1.17, and 1.18). Tacking
sutures at the distal end of the endarterectomy are not necessary unless the intima
does not appear to be well adherent to the arterial wall. In those circumstances, two
tacking sutures of a 7-0 cardiovascular polypropylene suture at 4 o’clock and at 8
o’clock positions are applied (Fig.1.19). Proximally, the plaque is usually sharply
divided by Potts scissors. In patients with thick atheromatous plaque proximally,
the vascular clamp is tightened to intentionally fracture the plaque, and this enables
the calcied core to be removed from the proximal end from the jaws of the clamp
(Figs.1.17 and 1.18), thus resulting in approximation of the intima to the wall of
the artery. All the debris are irrigated with heparinized saline and removed with a
ne pointed pickup. Arteriotomy is generally closed with a bovine patch graft
(Fig.1.20).
Fig. 1.16 Plaque being
separated with a dural
elevator (dissector)
(Hemostat is shown
separating the plaque. It
should be Freer also called
Peneld dural elevator)

14
Fig. 1.17 Proximal end of
the plaque is divided
sharply using a hemostat or
a Kelly clamp
S. S. Hans

1 Basic Arterial Techniques
Fig. 1.18 Distally, plaque
is divided or separated
until it ends as a
feathery end
Fig. 1.19 Tacking sutures
applied distally from the
intima to the adventitia to
prevent intimal ap
formation
15

16
Fig. 1.20 Patch closure
following endarterectomy
S. S. Hans

1 Basic Arterial Techniques
17
Semi-Closed Endarterectomy
Semi-closed endarterectomy can be performed where the plaque is considerably
longer than carotid or common femoral endarterectomy procedures. In this case, the
incision is shorter, and an instrument like a ring stripper or arterial dilators is passed
and the core of the plaque is separated from the outer wall with the help of Vollmar
ring stripper, which is passed in a spiral fashion while maintaining tension on the
artery. The dissected core is divided at the site of proximal arteriotomy and retrieved
from the distal end. The proximal and the distal intima are trimmed and secured.
This procedure is not commonly performed as there is a risk of perforation, embolization, and arterial thrombosis due to distal intimal ap. With the use of Garrett
arterial dilators (increasing size), from 3 to 6mm passed from proximal arteriotomy
to distal arteriotomy and then in a reverse fashion, the plaque is completely removed
with two small incisions and the intervening arterial wall is kept intact (Fig.1.21).
Primary closure or patch grafting at the arteriotomy site is performed depending
upon the anticipated size of the vessel following closure. This technique is described
in detail in the chapter on iliac and femoral endarterectomy.

18
Данная книга находится в списке для перевода на русский язык сайта https://meduniver.com/
S. S. Hans
Fig. 1.21 Semi-closed endarterectomy using arterial dilators (gradually increased size of dilators)
separating the plaque from the outer wall of the artery
Соседние файлы в папке Библиотека им академика М.И. Перельмана
