
- •Table of Contents
- •List of Tables
- •List of Figures
- •PART 1 DEFINITIONS
- •Chapter 1-2 Definitions of Transmission and Distribution Lines
- •Chapter 1-5 Definitions of Metering
- •Chapter 1-6 Definitions of Earthing
- •PART 2 GENERAL REQUIREMENTS
- •Chapter 2-2 Electrical Equipment
- •Chapter 2-2-1 The Selection of the Conductor Cross-Section Area
- •Chapter 2-2-2 The Selection of Electrical Equipment by Short Circuit Conditions
- •Chapter 2-3 Transmission and Distribution Lines
- •Chapter 2-3-1 House and Outside Wiring Systems with Voltage up to 35kV
- •Chapter 2-3-2 Power Cable Line Systems with voltage up to 220kV
- •Chapter 2-3-3 Overhead Power Line Systems with voltage up to 500kV
- •Chapter 2-4 Distribution Equipment up to 1kV
- •Chapter 2-5 Substations above 1kV
- •Chapter 2-6 Measure the electrical energy (Metering)
- •Chapter 2-6-1 Metering System
- •Chapter 2-6-2 Electrical Measurements
- •PART 3 TRANSMISSION AND DISTRIBUTION LINES
- •Chapter 3-1 House and Outside Wiring Systems with Voltage up to 35kV
- •Chapter 3-1-1 The Selection of Types of House and Outside Wirings with voltage up to 1kV and Installation Methods
- •Chapter 3-1-2 House Wirings with Voltage up to 1kV
- •Chapter 3-1-3 Outside Wirings with Voltage up to 1kV
- •Chapter 3-1-4 House and Outside Wirings with Voltages above 1kV up to 35kV
- •Chapter 3-2 Power Cable Line Systems with Voltage up to 220kV
- •Chapter 3-2-1 The Selection of Cables
- •Chapter 3-2-3 Special Requirements for Power Cable Lines
- •Chapter 3-2-4 Cables Installed Underground
- •Chapter 3-2-6 Installation of Cable Lines in Production Halls, Water or Special Structures
- •Chapter 3-3 Overhead Power Line Systems with Voltage up to 500kV
- •Chapter 3-3-1 Power Conductors and Lightning Conductors
- •Chapter 3-3-3 Insulators
- •Chapter 3-3-4 Power Line Accessories
- •Chapter 3-3-5 Overvoltage Protection
- •Chapter 3-3-6 Poles
- •Chapter 3-3-7 Particular Requirement
- •Chapter 3-3-8 Traversing Non-Populated Areas
- •Chapter 3-3-9 Traversing Populated Areas
- •Chapter 3-3-10 Traversing Areas with Water
- •Chapter 3-3-11 Crossing or Going Nearby Overhead Power Lines
- •Chapter 3-3-13 Crossing or Going Nearby Special Structures and/or Places
- •Chapter 4-1 Distribution Equipment up to 1kV
- •Chapter 4-1-1 Electric Equipment Installation
- •Chapter 4-1-2 Distribution Panel Boards
- •Chapter 4-2 Distribution Equipment and Substations above 1kV
- •Chapter 4-2-2 Indoor Distribution Equipment and Substations
- •Chapter 4-2-3 Workshop Substation
- •Chapter 4-2-4 Distribution Equipment and On-Pole Substation
- •Chapter 4-2-5 Lighting Protection
- •Chapter 4-2-6 Lightning Protection for Rotation Machine
- •Chapter 4-2-7 Internal Overvoltage Protection
- •Chapter 4-2-8 Installation of Power Transformers
- •Chapter 4-2-9 Battery Systems
- •PART 5 PROTECTIVE RELAYS AND CONTROL SYSTEMS
- •Chapter 5-1 Protective Relays up to 1kV
- •Chapter 5-2 Protective Relays above 1kV
- •Chapter 5-2-1 Common Protection Methods
- •Chapter 5-2-2 Protection of Generators
- •Chapter 5-2-3 Protection of Transformers and Shunt Reactors
- •Chapter 5-2-4 Protection of Transformer and Generator Blocks
- •Chapter 5-2-5 Protection of Overhead Lines and Cables with Isolated Neutral
- •Chapter 5-2-6 Protection of Overhead Lines and Cables with Efficient Earthed Neutral
- •Chapter 5-2-7 Protection of Compensating Capacitors
- •Chapter 5-2-8 Protection of Busbars
- •Chapter 5-2-9 Protection of Synchronous Compensators
- •Chapter 5-2-10 Protection of Underground Cable Lines
- •Chapter 5-3 Control Systems
- •Chapter 5-3-1 Control equipment and Auto-reclosers
- •Chapter 5-3-2 Auto Switching Power Supply Devices
- •Chapter 5-3-3 Auto-synchronization of Generators
- •Chapter 5-3-4 Auto-control Exciter Systems, Auto-control of Reactive Power, Auto-voltage Regulators
- •Chapter 5-3-5 Auto-control Frequency and Active Power
- •Chapter 5-3-6 Auto-prevention of Disturbances
- •Chapter 5-3-7 Auto-elimination of Asynchronous Mode
- •Chapter 5-3-8 Auto-prevention of Frequency Decrease
- •Chapter 5-3-9 Auto-prevention of Frequency Increase
- •Chapter 5-3-10 Auto-prevention of Voltage Decrease
- •Chapter 5-3-11 Auto-prevention of Voltage Increase
- •Chapter 5-3-13 Remote Telecontrol Systems
- •Chapter 5-4 Secondary Circuits
- •PART 6 EARTHING
- •Chapter 6-1 Purpose of earthing
- •Chapter 6-2 Components to be Earthed in Power Networks
- •Chapter 6-3 Components to be Earthed in Electrical Equipment
- •Chapter 6-4 Components Exempt from Earthing
- •Chapter 6-5 Protection against Earth Faults
- •Chapter 6-6 Earth Resistance Requirements of Earthing System
- •Chapter 6-7 Calculation of Earth Fault Current
- •Chapter 6-8 Earthing Conductors
- •Chapter 6-9 Installation Method of Earthing Systems
- •Chapter 6-10 Alternatives to Earthing Conductors
- •Chapter 6-11 Earthing of Mobile Electrical Equipment
- •Annex II.2.1 (I.3A)
- •Annex II.2.2 (I.3B)
- •Annex II.2.3 (I.3C)
- •Annex III.1 (II.1)
- •Annex III.3 (II.4)

Chapter 1-4 Definitions of Protective Relays and Control
Systems
Article 14. Protective Devices
As stipulated in Technical Regulation.
Article 15. Types of Protection
As stipulated in Technical Regulation.
Article 16. Remote Control Systems
As stipulated in Technical Regulation.
Article 17. Secondary Circuits
As stipulated in Technical Regulation.
Chapter 1-5 Definitions of Metering
Article 18. Electricity Meter
As stipulated in Technical Regulation.
Article 19. Multi Tariff Meter
As stipulated in Technical Regulation.
Article 20. Checking Meter
As stipulated in Technical Regulation.
Chapter 1-6 Definitions of Earthing
Article 21. Earth Fault
As stipulated in Technical Regulation.
Article 22. Earthing System
1)Earthing Electrode
2)Earthing Conductors
As stipulated in Technical Regulation.
12

Article 23. Zero Area of Voltage
As stipulated in Technical Regulation.
Article 24. Resistance of Earthing
As stipulated in Technical Regulation.
Article 25. Earth Fault Current
1)Large Earth Fault Current
2)Small Earth Fault Current
As stipulated in Technical Regulation.
Article 26. Neutral of Power System
For 500kV, 220kV, 110kV, 22kV and 15kVpower system, direct grounding is applied to itsneutral. Grid 6kV, 10kV, 35kV is isolated neutral with arc-suppression coil, in special cases can be grounded directly.
|
Table 26 |
Neutral point grounding method |
Voltage level |
|
Neutral point grounding method |
|
|
|
110,220,500kV |
Direct grounding |
|
|
|
|
35kV |
Isolated neutral or Resistance grounding |
|
|
|
|
15, 22kV |
Direct grounding (3-phase 3-wire) or grounding repeatedly (3-phase 4-wire) |
|
|
|
|
6, 10kV |
Isolated neutral |
|
|
|
|
less than 1kV |
Direct grounding (grounding neutral, grounding repeatedly, neutral earthing |
|
combined) |
|
|
|
|
|
|
|
|
1)Direct earthed neutral
2)Isolated Neutral
3)Effective Earthed Neutral
4)Neutral Conductor
As stipulated in Technical Regulation.
Article 27. Protective Breaking
As stipulated in Technical Regulation.
Article 28. Main Insulation
As stipulated in Technical Regulation.
13

Article 29. Auxiliary Insulation
As stipulated in Technical Regulation.
Article 30. Double Insulation
As stipulated in Technical Regulation.
14