18. Read the text and speak on the main types of emitters. Text d. Types of Emitters.

There are many variations in the method of transferring the heat from hot water, steam, or electric resistors to the space to be heated. The most familiar heat emitter in older buildings is the common radiator. Steam or hot water circulates through its hollow sections, which can be connected to each other to produce varying lengths. Radiators are usually placed along the external walls of a room. Ambient air enters from below and in front of the radiator, and as it becomes heated it rises vertically between the radiator sections and discharges at the top. The warmed air, being less dense than the cooler air further away in the room, rises and displaces the cooler air, which falls, setting up a current of air.

Convectors differ from radiators in their smaller heat–transfer surface and their placement at the bottom of a cabinet whose inlets and outlets are designed to properly direct a stream of warmed air through the room using the same "chimney" effect. The typical convector is an arrangement of finned pipes or coils through which the heated air or water circulates at the base of an enclosure open at the top and bottom. Air flows upward over the heating surface and is discharged at the top of the enclosure; cooled air drops to the floor and reenters the convector. Such convectors are often installed along windows or along an external wall to counteract drafts and the loss of heat through those cold surfaces.

Many industrial buildings are heated using a special form of emitter called a unit heater, which consists of (1) an arrangement of finned tubes through which hot water or steam circulates and (2) an electric fan that forces air over the tubes. The forced convection results in a rapid rate of heat transfer. Unit heaters can be mounted in units either above the floor or on it.

Radiant heating systems usually employ either hot–water pipes embedded in the floor or ceiling, warm–air ducts embedded in the floor, or some form of electrical resistance panels applied to ceiling or walls.

Panel heating is a form of radiant heating characterized by very large radiant surfaces (an entire ceiling or floor is typically employed) at modestly warm temperatures. With many such systems there is no visible heating equipment in the room, which is an advantage in decorating. A disadvantage is the extent to which a ceiling or floor might be ruined in case of corroded or faulty hot–water piping where this method is employed.

Notes:

electric resistor – электрический резистор

hollow – пустой, полый

displace – вытеснять, заменять, замещать

mount – монтировать, устанавливать

Follow up activities

19. Read the texts a and b. Make notes under the following headings. Then use your notes and the illustrations to talk on the topics.

1. Central Heating Systems. Principles and Design

2. Warm–air and Hot –water Heating Systems.

Unit III air coditioning and ventilating

Active Vocabulary