Development of fall of testing

Mishina A.V., Nagiev A.T., Ovchinikov M.V.

Tuymen State Oil and Gas University, Tyumen, Russia

genaevangel@mail.ru

The main task of the this research is studying of water injection according to well testing on an example of the Samotlor field and perfection of methods of interpretation of. Pressure drawdown curves of long time in shut wells, as a rule, turn out with the original "zigzag" marked on recorded curves in 3-4 hours after shut of wells.

If manometer is established in tubing on depth of an interval of perforation or a little above it then it rigorously fixes all process of pressure decrease in a well. Set of the well tests shown in the fig. is also ranks to such records.

Fig. Pressure Drawdown Curves of wells №№ 35444, 35490.

Wells №№ 35444, 35490 have a sharp break at pressure around 170 аt - this pressure corresponds to hydrostatic pressure of a column of water in a well. The reason of a bend of curves is connected by that the well test before pressure decrease to the specified size (170 аt) is registered in the conditions of compressibility of water in the closed space of a well and rate of pressure decrease is completely defined by transient occurring processes in a layer: at high permeability rate of decrease low, at low permeability rate of decrease the high. However when pressure in a well becomes equal to hydrostatic pressure, the subsequent pressure decrease in a well is already defined by not only filtration properties of a layer, but also by the capacity of a trunk of a well, i.e. the fall of level of a liquid in a well mainly defines now rate of decrease wellbore pressure. Recorded pressure in the given wells is below hydrostatic pressure. Apparently, indemnification of production and injection around such wells are not reached.

Pressure distribution in a layer at inflow of gas taking into account change of factor of compressibility of gas

Pirieva M.A., Romashkin S.V., Burmistrov N.A.

Tyumen State Oil and Gas University, Tyumen, Russia

genaevangel@mail.ru

According to the law of Darcy for a radial stream filtration process a fluid in a layer is described logarithmic by dependences:

Р(r) = Р _w + qμ/(2πkh )· ln (r /r_w ) , (1)

where P_i – initial pressure, P(r) – pressure in a layer on distance r from a wellbore, Р_w - pressure in a well, q – rate in wellbore, μ – liquids viscosity, k – permeability of a layer, h –thickness of a layer, r – radius of a contour, r_w – well radius.

Formulas (1) are written down for inflow in the well measured on a face of a well, and consequently it take place to any fluid-gas and oil, and their mixes. However, as practically always inflow characteristics are estimated on gaugings of an arriving fluid on a surface settlement dependences put into practice differ. For oil and oil mixes factors of B_o and B_m are usually entered.

For the gas mixes which are strongly liquids, it is accepted to estimate change of an output for wellbore conditions taking into account change of density of gas in a well on the basis of the known equation of a condition for hydrocarbonic gases PV = ZRT , where Р, V, T – pressure, volume and temperature, R - universal gas constant, Z - supercompressibility factor. For gas well equation (1) changing as:

P_wb² = P_av²+(q_sZ P_s T/ P·T_s)·μ/(2πKh )·ln (r/ r_w), (2)

where the data on a well and on a external contour is taken into consideration only, and also some average value Z is applied to all area of drainage such approach, basically, is admissible for practical calculations.

In effect, the problem is reduced to finding Р(r) by summation of differences of pressure on layer sites on radius from a well with r = r_i to required r_i+1 with pressure Р(r) with updating of value Z on each step:

, . (3)

As a result of the calculation of schedules of pressure executed thus the dependences, resulted on fig. are received. Schedules are constructed in co-ordinates P from lg r more obviously to see those deviations which take place at comparison of the rough accelerated calculation and calculation taking into account change Z from R.

A s a whole the resulted calculations show that, applying the specified method of the account of influence of pressure and temperature on change of factor of supercompressibility, layer parameters in 1,5 – 2,0 times different from calculation by simplified techniques turn out.

Fig. Schedules of change of pressure in a layer, constructed with the account ; Changes Z from pressure – (1) and without taking into account – (2)

It is interesting that practically in all books and practical guidances under the analysis and interpretation of display diagrams of pressure similar curvature IC always contacted a nonlinear stream of a filtration of a liquid in a layer, described two-members the equation: _, where A and B - the factors of filtrational resistance depending on imperfection of a well, zone geometry of drainage, parameters and properties of gas.

So we received curvature IC is not connected absolutely not with nonlinearity of the law of a filtration.

The computer programs allowing on the personal computer quickly to carry out specified procedures are developed.