Добавил:
Upload Опубликованный материал нарушает ваши авторские права? Сообщите нам.
Вуз: Предмет: Файл:
Англійська мова.doc
Скачиваний:
0
Добавлен:
30.12.2019
Размер:
9.64 Mб
Скачать

Writing

I. Yesterday you were watching how some students were experimenting in the lab. Describe their activities. The words below will help you.

t o use

to measure

to hold

to turn

to indicate

the function selector switch

the resistance range

the ohms scale

II. Translate the text into Ukrainian. Use the dictionary if necessary.

The students of the Technical University were carrying out an experi­ment with a miltimeter in the lab last week. They had checked a mains sock­et in the wall and they had followed all the safety instructions before the beginning of the experiment. During the experiment Paul was using two probes that time. While he was inserting them into two terminals of the socket, his groupmate Alex was turning the function selector switch to the VAC (voltage alternating current) range. The needle was indicating the pressure of electricity, i.e. the voltage in the mains. Everybody was watching the indications on the volts scale. It was 220 volts. Next time they are planning to measure the current in a table lamp.

Further Reading

I. Learn the following words and word-combinations to comprehend the text.

act

low

apply

other

believe

outside

charge

point

contain

petrol

consider

raise

convert

reach

efficiency

report

employ

result (in)

enough

run (ran, run)

expect

suppose

find (found, found)

throttle

inside

usual

invent

before

know (knew, known)

instead of

II. Read and translate the text. Diesel Starting Systems

Some diesels use an additional gasoline engine for starting. The small engine is attached to the diesel by means of a clutch. The gasoline engine is known to crank the diesel until the diesel starts. Exhaust from the starting engine is used to heat the intake manifold of the die­sel engine. After a short warm-up period, the compres­sion lever is returned to normal position and the throttle valve opened so that the diesel will start.

Most farm tractor diesels use electric starting motors similar to those used in gasoline engine tractors. They are operated from the battery on the tractor. In warm weather starting is usually not a problem, but for cold-weather starting there are several starting aids. Some tractors are equipped with electric plugs to heat the intake manifold before starting the engine. The heated in­take manifold warms the air entering the engine so that the engine will start when cranked by the starter.

To start an engine ether may also be used. Ether has a low ignition point so that the heat of compression in cold weather is enough to ignite the ether. This will then ignite the fuel charge.

Ether is highly explosive and must be injected into the engine only when the starter is cranking the engine. Engine-block heaters can also be used to start the diesel engine. These heaters are usually electrically operated and heat either the oil in the crankcase or the engine coolant.

warm-up period

період нагрівання (прогріву)

starting aid

пристрій для пуску двигуна

IIІ. Answer the questions.

1. Some diesels use an additional gasoline engine for starting, don’t they?

2. Why do we use several starting aids for starting in cold weather?

3. Why are some tractors equipped with electric plugs?

4. What are the main characteristics of ether?

IV. Retell the text.

14.

Copper

Modal Verbs

Copper Application in Engineering