- •General
- •Multmeter
- •1.2 Measuring signals with the multimeter
- •1. Sine-wave signal (alternating voltage)
- •Description of components
- •Engine speed and vehicle speed sensors
- •Temperature sensors
- •2.3 Fluid-level sensors
- •2.4 Pressure sensors
- •2.5 Proximity sensors
- •Inductive proximity sensors
- •Inspection and adjustment
- •Checking electrical systems
- •4. Removal and installation
- •Removing and installing contacts from connectors
- •Installing contact units on electrical wires
- •4.4 Removal and installation of contact units of connectors with single contact lock
- •Removal and installation of contact units of connectors with additional contact lock
General
Multmeter
Multimeters are available in two different versions:
analog meter
digital meter
An analog meter has an indicating needle (pointer) which can move over a graduated scale.
A digital meter indicates the measured values by means of digits in a read-out window
Analog meter
Disadvantages:
Difficult to read due to the various graduated scales.
Not capable of giving precision readings (depending on the scale arrangement/measuring range).
If the meter is connected up incorrectly, there is a real risk of electrical defects in the meter.
The indicating needle (pointer) is not resistant to powerful mechanical vibrations The meter must usually be used in a certain position.
Advantages:
Useful, for example, when measuring a potentiometer with a minor interruption.
Digital meter
Disadvantages:
Meter is slow. With a fluctuating voltage all you can see are flashing digits.
Advantages:
It indicates the correct value without the risk of misinterpretation.
Gives more accurate readings.
It is protected against faulty connection.
It is resistant to powerful mechanical vibrations.
It can be used in any position
General
Key to the symbols on analog meters.
The following symbols may occur on an analog meter
Moving-coil meter with permanent magnet.
Moving-coil meter with rectifier cell.
Electromagnetic or soft-iron meter.
With rectifier cell.
Suitable for direct current.
Suitable for alternating current
Suitable tor direct current and alternating current.
Meter with zero adjustment
Meter may only be used in the vertical position.
Meter may only be used in the horizontal position.
Test voltage is 2 kilovolts (without a digit it is 0.5 kilovolt).
Meter may only be used at the angle indicated.
Suitable for direct current class 1.5 (inaccuracy 1.5% of full scale).
Suitable for direct current and alternating current classes 1 and 0.5 (see item 13 for explanation).
Units of measurement
The multimeter should be set to the range applicable to the unit of measurement required. For example: the voltage range, current range or resistance range.
1. Direct voltage
2. Alternating voltage
3. Direct current
4. Alternating current
5. Resistor
6. Duty-cycle
7. Frequency
1.2 Measuring signals with the multimeter
1. Sine-wave signal (alternating voltage)
The signal regularly changes polarity with respect to the '0’ line.
Frequency
The frequency is indicated in Hertz (Hz).
The number of complete sines per second is the frequency of the signal (3 Hz in the figure shown opposite).
Voltage
When the number of sines per second increases, not only the frequency increases but also the voltage.
Measuring a sine-wave signal
There are two ways of measuring a sine-wave signal with a multimeter:
With the multimeter set to the frequency (Hz) position.
This is measuring the number of complete sines per second.
With the multimeter set to the alternating voltage position.
This is measuring the mean voltage.
Sine-wave signals on the vehicle Output signal of ABS sensor.
Output signal of engine speed sensor