Introduction to the suck-a-matron device (implosion tech)

Based on principle of power out is equal to power in or less (minus entropy) OU: is the Power out summed (transformed) into the acquired power in the system to equal or surpasses the power input of the system. In the suck-a-matron process Power creates a vacuum (vortex). The exterior air at an X density then performs work as it tries to fill the void. It then adds more density and drops down gravity assisted (centrifugal force) gaining MORE energy. As it does it is extracted requiring only a small percent of the original energy. This is because the conditions of a higher density and pressure (liquid air) in an EXTREME Thermal reactor configuration. Where energy is used near 100% and the energy sink is totally isolated.

The thermodynamic LAW is as follows: Transformation where Energy out exceeds the energy in. The energy input is transformed and acquires energy from the density reduction via the depleted air sinking to the bottom of the unit extracted by the RV type vacuum pump. This is using much less energy than the one created in the input turbine generator to transform it. The raw basics were tested and gave competent results. Using a vortex method it creates anti gravity thrust (implosion).

The RV technology can be integrated as part of a co-generation construct, proper funding and resources is still needed to perfect concept.

Operating principle introduction

http://www.deutsches-museum.de/ausstell/dauer/physik/e_luft.htm Hot air being sucked in performs the first work in thermally insulated turbine stages where as the above thermodynamic law describes. It then cools down further as it performs more work gaining more density where the gravity imparts this energy as it flows down through a SINK, pipe or structure designed for such action.

The energy being denser is resulting in the creation of more vacuum force until such air becomes a liquid state as it reaches the lower level in such a pipe or structure. In a pure turbine design the AIR gets denser and by means of a centrifugal cryo pump is removed requiring a fraction of the energy produced by the turbines being self sustaining using PURE heat as FUEL.

The same interpretation comes from considering Hurricanes and Tornados functions. Where we create an artificial condition where the Carl von Linde principle works performing WORK and creating a self sustaining sink, the main factor is the isolation of the COLD sink once the process is created.

Operating principle

You suck air, it enters in at a 14.7 PSI 11psi average and does work at 98% efficiency as in an air turbine. Then self cools like in hurricane and is extracted at 1/273 more density per degree as it cools down performing more work, using the gravity in long chimney structure and the unit self runs.

This is based on the concept of the excess energy comes from the ATMOSPHERIC PRESSURE as we all walking around on the earth under 1 bar pressure. Consider a

Thermally isolated vertical pipe (like chimney stack ) containing foam insulated inside out assisted with an air turbine on top and operating with a suction from the bottom using the RV.

As air performs WORK it becomes dense to LIQUID and goes down to the machine creating a vacuum. A created temperature difference mapped to the applied energy for separation yields a gravity assisted bottom sucking (extraction).The pressure which earth atmosphere uses to fill the middle of the tube (cold region). ALL the tube after it exits the turbine being an INSULATED HEAVY DENSITY

GOES Down the pipe sucked from the bottom by the effect from the RV vacuuming pump. Because of the lower molecular air density is "for free". It is OU. It’s a simple 2085 heat transformation engine constructed with the ideas.

Design details that need to be addressed is the WATER must be fractioned in the way down before freezing, to avoid clogging the machine (Icing). The gases can be also fractioned making the machine a liquid gas manufacturing complex ,Oxygen for hospitals CO² for fire suppressing devices and food industry & others and rare gases for industry.

There may need to be additional empirical experiments to solve details and design problems.

Schauberger turbine co-generation

Some examples of schuaberger designs involving implosion

For co-generation the RV is also MOTOR generator initiator for this device and it

generates anti gravity (lift) in an effect described as centrifugal vector redirection were rotary force transfers to a linear one by transition relative movement null. This has been verified from experimenting with sono-fusion turbines creating sonic rotary cavities for water resonance.

For Viktor Schauberger type turbine designs-

http://www.frank.germano.com/index.htm

Open sourced engineers really need resources to do TURBINE R&D with the RV prime mover, seal optimization, drag reducing impeller redesign for Tesla or vortex cavitations modes.